How to Set  Your Subsonic Filter for Ported and Sealed Subwoofers - Stinger

Optimizing Your Bass: Subsonic Filter Settings for Ported and Sealed Subwoofers

In this comprehensive guide, we'll unravel the process of subsonic filter setup for both sealed and ported subwoofer enclosures. Before we move forward, let us start with the basics!

You will find different types of car subwoofer enclosures in the market, such as ported and sealed; both need to be tuned to their specific frequency. A subsonic filter is a circuit that filters out low-frequency signals below a specific cutoff. Subwoofers are a crucial aspect of any car audio system, and it is equally important to know how to set up a subsonic filter to protect your subwoofer and make it sound great.

Ported Enclosures

The first step in setting up a subsonic filter for a ported enclosure is determining the frequency at which the port will resonate. This can be done by measuring the length and diameter and using a formula to calculate the resonance frequency. Once you know the resonance frequency, you can set the subsonic filter to cut off at a frequency slightly below the port resonance frequency.

Sold out

Sold out

Sold out

Sealed Enclosures

Setting up a subsonic filter for a sealed enclosure is relatively straightforward. Since sealed enclosures do not have ports, you will not need to worry about the resonance frequency of the port. Instead, you need to set the subsonic filter to a frequency slightly below the lowest frequency your subwoofer can comfortably play. This will ensure that the subwoofer isn't playing frequencies it can't handle and does not cause any damage.

Sold out

Sold out

Sold out

Benefits of Setting Up a Subsonic Filter

  • First, it can protect your subwoofer from damage by filtering out low-frequency signals that the subwoofer can't handle.
  • Second, it can help improve the sound quality of your subwoofer by ensuring that it's playing frequencies it can comfortably handle.
  • Finally, it can help you save power by preventing your amplifier from sending low-frequency signals to your subwoofer that can't be reproduced.

How to Set Up Your Subsonic Filter

Step One: Determining the Subsonic Filter Frequency

Start by checking the subwoofer and enclosure specifications and look for the recommended subsonic filter frequency range provided by the manufacturer.

For ported enclosures, it is usually mentioned as a recommended low-pass frequency or a range (e.g., 20 Hz to 35 Hz).

If there are no specific recommendations, set the subsonic filter frequency a half octave below the enclosure tuning or around 80% of the enclosure tuning frequency for easier calculation.

For example, if enclosure tuning is 35 Hz, set the subsonic filter to 28 Hz. The tuning frequency can commonly be found in the manufacturer's enclosure documentation or specifications.

Step Two: Set the Subsonic Filter

Access the subsonic filter settings on your car amplifier, receiver, or dedicated subwoofer crossover.

Set the subsonic filter frequency to the determined value of your selected audio equipment. Adjust the control knob or enter the frequency in the settings menu, depending on your equipment.

Step Three: Fine-tune the Subsonic Filter

Run a test by playing audio material containing low-frequency content, such as music tracks with deep bass. Listen carefully for distortion or excessive cone movement that might indicate low-frequency signals below the subsonic filter frequency.

If you notice any distortion or excessive cone movement, gradually increase the subsonic filter frequency until the unwanted frequencies are eliminated. Be cautious not to go too high and remove desired bass content.

Remember to always reference the manufacturer's recommendations for your specific subwoofers, enclosures, and audio equipment. Fine-tuning may require some experimentation based on your listening preferences and the characteristics of your system.

If your equipment has a slope adjustment, you can experiment with different slope settings to find the best balance between eliminating low frequencies and maintaining a smooth transition.

We hope this article has helped you through setting up a subsonic filter for a ported or sealed enclosure. Let us know in the comments below what we should cover next!

Customer Favorites

Leave a comment

All comments are moderated before being published